Chapter9: Configuring Frame Relay Interworking
Avidia System Configuration and Management User Manual 223
[-txlpmode (1|2)]
The Tx LP mode determines the content of the FR-SSCS PDU header DE and ATM cell
ATM CLP fields.
1—The frame header DE field is copied in the FR-SSCS PDU header DE field and mapped
into the ATM CLP field of every ATM cell generated by the frame.
2—The frame header DE field is copied into the FR-SSCS PDU header DE field. The ATM
CLP field of every ATM cell generated by the segmentation process of the AAL5 PDU
containing the information of that frame is set to the CLP mask value.
[-clpmask (0|1)]
The CLP Mask determines the content of the ATM cell CLP field when the Tx LP mode is
set to 2.
0—The network cannot discard cells.
1—The network can discard cells.
[-rxlpmode (1|2)]
The Rx LP mode determines the loss priority settings when transmitting from ATM to
frame relay.
1—The frame relay header DE field is set if the CLP field of one or more ATM cells of a
frame is set to 1 or if the FR-SSCS PDU header DE field is set to 1.
2—The frame relay header DE field is copied into the FR-SSCS PDU header DE field,
independent of the ATM CLP field value received.
[-CIR <value>]
The circuit throughput (committed information rate) value in seconds. The valid range is 0
to 144000, with 0 as the default.
[-Be <value>]
The excess burst is the maximum number of uncommitted data bits that the network will
attempt to deliver. The valid range is 0 to 144000, with 144000 as the default.
[-Bc <value>]
The committed burst is the maximum number of data bits that the network agrees to transfer
under normal conditions during the measurement interval. The valid range is 0 to 144000,
with 0 as the default.
Example
::frf5=> set 2 -admin down -txlpmode 2 -clpmask 0