Configuring IP Routing
236 Avidia System Configuration and Management User Manual
Adding IP Routing Table Entries
From the ::routingtb=> prompt type the new command in the following format, then press
.
new <destip> <nexthop> [-hopcount <hopcount>]
Parameters
<destip>
The IP address to which packets must be sent to qualify for routing based on this IP Routing
Table entry.
<nexthop>
The IP address of the next router in the network to which the packet is to be forwarded.
[-hopcount <hopcount>]
The number of hops the packet is allowed to make to get to its destination. If the packet
makes the maximum number of hops allowed by the RIP configuration (see “Modifying
RIP Configuration” on page 242), and is not yet at its destination, it is deleted.
Example
::routingtb=> new 100.90.57.3 100.90.57.4 -hopcount 10
Displaying the IP Routing Table
To verify your IP routing configuration, from the ::routingtb=> prompt, type the show
command as follows then press .
show [<ipaddr>]
Parameter
[<ipaddr>]
The IP address of the IP Routing Table entry you want to display (format xxx.xxx.xxx.xxx).
Omitting this parameter displays all IP Routing Table entries.
ENTER
ENTER