ADC SWD4573I1 - page 77

Chapter3: Applications and Configuration Overview

Avidia System Configuration and Management User Manual 51

Configure Service. For each card that is subtending or subtended, configure the applicable

service:

•DS1/DSX-1: see “Configuring DS1 Service” on page 143 (command-line interface) or

“Configuring DS1 Service” on page417 (Web interface)

•DS3: see “Configuring DS3 Service” on page 149 (command-line interface) or

“Configuring DS3 Service” on page422 (Web interface)

•OC3 service: see “Configuring OC3 Service” on page142 (command-line interface) or

“Configuring OC3 Service” on page416 (Web interface)

Configure ATM Connections. Configure the PVCs (ATM circuits), using the profiles that

you created for service (see “Configuring ATM Virtual Circuits” on page 153 for the

command-line interface or “Configuring ATM Virtual Circuits” on page 427 for the Web

interface). Essentially, these are the connections you must set up, as shown in the following

figure:

•from the subtended card port to the subtending card port

•from each subtending card port to the network uplink card (cross-connects)

•from the network uplink card (line interface) port to the ATM switch

The network administrator will assign the VPI/VCI values. The values shown in the above

illustration are for example only. The network administrator can set up VPI/VCI values in a

meaningful way to differentiate between nodes or areas of subtended sites.

Site A

Site B

Site C

ATM

Switch

VPI 6

VCI 1

PVP

(or use three

PVCs instead

of one PVP)

VPI 6

VCI 1

DS1

VPI 3

VCI 1

VPI 9

VCI 1

VPI 9

VCI 1

VPI 3

VCI 1

Subtending

Cross-connects

DS1 OC3

DS1

Subtended