|
| Figure 8- 8. SNMP Community Table Configuration and Table window | |
The following parameters can be set: |
|
| |
| Parameter | Description |
|
| Community Name | Type an alphanumeric string of up to 33 characters that is used to identify members of an SNMP community. | |
|
| This string is used like a password to give remote SNMP managers access to MIB objects in the Switch's SNMP | |
| View Name | agent. | |
| Type an alphanumeric string of up to 32 characters that is used to identify the group of MIB objects that a | ||
| Access Right | remote SNMP manager is allowed to access on the Switch.The view name must exist in the SNMP View Table. | |
| Read Only – Specifies that SNMP community members using the community string created can only read the | ||
|
| contents of the MIBs on the Switch. | |
|
| Read Write – Specifies that SNMP community members using the community string created can read from, and | |
|
| write to the contents of the MIBs on the Switch. |
|
To implement the new settings, click Apply.To delete an entry from the SNMP Community Table, click the ✘ under the Delete heading, corresponding to the entry you wish to delete.
SNMP Host Table
Use the SNMP Host Table to set up SNMP trap recipients.
Open the SNMP Manager folder and click on the SNMP Host Table link.This will open the SNMP Host Table page, as shown below. To delete an existing SNMP Host Table entry, click the corresponding ✘ under the Delete heading.
To display the current settings for an existing SNMP Group Table entry, click the blue link for the entry under the Host IP Address heading.
Figure 8- 9. SNMP Host Table
To add a new entry to the Switch's SNMP Host Table, click the Add button in the upper left-hand corner of the page.This will open the SNMP Host Table Configuration page, as shown below.
Allied Telesyn | 154 |
