Allied Telesis AT-9724TS specifications Gvrp Setting, Port Settings Tag None Egress Forbidden

Port Settings

Tag

None

Egress

Forbidden

User Defined Pid – Specifies that the VLAN will only accept packets with this hexadecimal 802.1Q Ethernet type value in the packet header.The user may define an entry, in the hexadecimal form (ffff) to define the packet identification. (The user only need enter the final four integers of the hexadecimal format to define the packet ID –{hex 0x0 0xffff}) This field is only operable if userDefined is selected in the Protocol ID field.

encap [ethernet llc snap all] – Specifies that the Switch will examine the octet of the packet header referring to one of the protocols listed (Ethernet, LLC or SNAP), looking for a match of the hexadecimal value previously entered . all will instruct the Switch to examine the total packet header.After a match is found, the Switch will forward the packet to this VLAN.This field is only operable if userDefined is selected in the Protocol ID field.

Allows an individual port to be specified as member of a VLAN.

Specifies the port as either 802.1Q tagging or 802.1Q untagged. Checking the box will designate the port as Tagged.

Allows an individual port to be specified as a non-VLAN member.

Select this to specify the port as a static member of the VLAN. Egress member ports are ports that will be transmitting traffic for the VLAN.These ports can be either tagged or untagged.

Select this to specify the port as not being a member of the VLAN and that the port is forbidden from becoming a member of the VLAN dynamically.

Click Apply to implement changes made. Click the Show All Static VLAN Entries link to return to the Current 802.1Q Static VLAN Entries window.

GVRP Setting

In the Configuration menu, open the VLANs folder and click GVRP Setting.

The 802.1Q Port Settings dialog box, shown below, allows you to determine whether the Switch will share its VLAN configuration information with other GARP VLAN Registration Protocol (GVRP) enabled switches. In addition, Ingress Checking can be used to limit traffic by filtering incoming packets whose PVID does not match the PVID of the port. Results can be seen in the table under the configuration settings, as seen below.

Figure 6- 43. GVRP Settings and Table window

Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch 62