Allied Telesis AT-9724TS specifications Config Firmware Image, Box, Size, Update Time

Figure 10- 5. Firmware Information window

This window holds the following information:

Parameter	Description
BOX	States the stacking ID number of the switch in the switch stack.
ID	States the image ID number of the firmware in the Switch’s memory.The Switch can store 2 firmware images
Version	for use. Image ID 1 will be the default boot up firmware for the Switch unless otherwise configured by the user.
	States the firmware version.
Size	States the size of the corresponding firmware, in bytes.
Update Time	States the specific time the firmware version was downloaded to the Switch.
From	States the IP address of the origin of the firmware.There are four ways firmware may be downloaded to the
	Switch.
	R – If the IP address has this letter attached to it, it denotes a firmware upgrade through the Console Serial
	Port (RS-232).
	T – If the IP address has this letter attached to it, it denotes a firmware upgrade through Telnet.
	S – If the IP address has this letter attached to it, it denotes a firmware upgrade through the Simple Network
	Management Protocol (SNMP).
	W – If the IP address has this letter attached to it, it denotes a firmware upgrade through the web-based
User	management interface.
	States the user who downloaded the firmware.This field may read “Anonymous” or “Unknown” for users that
	are not identified.

Config Firmware Image

The Config Firmware Image window allows users to configure firmware images saved in the memory of the Switch.To access the following window, click Maintenance > MULTIPLE IMAGE Services > Config Firmware Image.

Figure 10- 6. Config Firmware Image window

Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch 186