AT&T DS1/DMi/ISDN-PRI manual BRI Only, PRI and BRI Layer 2 Parameters

	ADMINISTRATION OPTIONS AND REQUIREMENTS — GENERIC 2	7-65
Field 20	This display-only field serves to show which cables contain which synchronization
	cables.

Procedure 262 Word 1: Additional DMI-MOS/ISDN-PRI Facility Options

Procedure 262 is used to administer the ANN35 and TN767 circuit packs. Figure 7-29, Procedure 262 Word 1: Additional DMI-MOS/ISDN-PRI Facility Options (Generic 2), depicts this procedure.

ENHANCED MODE - PROCEDURE: 262, WORD: 1

ISDN BOARD PARAMETERS

EQUIPMENT LOCATION 13. PRI Interface Identifier:

1.Module:

2.Cabinet:

3.Carrier:

4.Slot:

5.Circuit:

PRI PARAMETERS

6.Interface Type:

7.Facility Test Code:

8.Terminal Endpoint Identifier:

PRI AND BRI LAYER 2 PARAMETERS

9.Timer T203:

10.Timer T200:

11.Counter N200:

12.Counter K:

Connect to CC0 ON-LINE

enter command:

Figure 7-29.Procedure 262 Word 1: Additional DMI-MOS/ISDN-PRI Facility Options (Generic 2)

Fields 1-4	Assigns the circuit pack to an equipment location. These include the module
	number, cabinet number, Port carrier number, and slot number.
	NOTE: Entries for these four fields are the default values from translating a
	five in field 14 of procedure 260. These entries should always be correct.
Field 5	BRI Only
	For ISDN-PRI and DMI-MOS applications, the dash (–)is appropriate.