AT&T DS1/DMi/ISDN-PRI manual Port, Name, Mode, Answer, Delay

ADMINISTRATION OPTIONS AND REQUIREMENTS — SYSTEM 75 7-113

Trunk Type Establishes the physical type of incoming and outgoing trunks. For tie trunk

(in/out)applications, field encodes and their descriptions are:

●Auto

●Immed-start

●Wink-start

●Delay-dial

Figure 7-58,Trunk Group Screen,				Page 2, depicts this procedure.
		GROUP		MEMBER	ASSIGNMENTS	Page 2 of 5
	Port	Name		M o d e	Type	Answer Delay
	1: _ _ _ _ _	_______	________		______	__________
	2: _ _ _ _ _	_______	________		______	__________
	3: _ _ _ _ _	_______	________		______	__________
	4: _ _ _ _ _	_______	________		______	__________
	5: _ _ _ _ _	_______	________		______	__________
	6: _ _ _ _ _	_______	________		______	__________
	7: _ _ _ _ _	_______	________		______	__________
	8: _ _ _ _ _	_______	________		______	__________
	9: _ _ _ _ _	_______	________		______	__________
	10: _ _ _ _ _	_______	________		______	__________
	11: _ _ _ _ _	_______	________		______	__________
	12: _ _ _ _ _	_______	________		______	__________
	13: _ _ _ _ _	_______	________		______	__________
	14: _ _ _ _ _	_______	________		______	__________
	15: _ _ _ _ _	_______	________		______	__________

	Figure 7-58.Trunk Group Screen, Page 2
Port	This field associates each trunk group member to a particular carrier (A-E), slot
	(01-20), and circuit (01-24).
	NOTE: System 75 does not have the same DS1 circuit pack slot restrictions as
	System 85. However, trunk group member assignments should match the DS1
	channel assignments (for example, trunk group member 1 on channel 1) and
	maintain this procedure as long as possible.
Name	This field does not apply to PRI.
Mode	For DS1 tie trunk applications, the default and only permitted entry is e&m.
Type	For DS1/DMI applications, the default is T1 stan (T1 standard). Normally, this
	field is not administered. The default value is appropriate.
Answer	Allowable entries (in milliseconds) range from 20 to 5100 in intervals of 20. This
Delay	field should only be translated if delay-dial were optioned.