AT&T DS1/DMi/ISDN-PRI manual Procedure 321 Word 5 AAR-ISDN and Other Feature Parameters

7-104ADMINISTRATION OPTIONS AND REQUIREMENTS — GENERIC 2

Procedure 321 Word 5: AAR–ISDN and Other Feature Parameters

This procedure is required for translating ISDN trunk groups into the AAR plan. Figure 7-52, Procedure 321 Word 5: AAR–ISDN and Other Feature Parameters, depicts this procedure.

ENHANCED MODE - PROCEDURE: 321, WORD: 5

AAR - ISDN AND BEARER CAPABILITY COS

1.Pattern Number:

2.Preference Number:

3.ISDN Dynamic Trunk Type:

4.ISDN Network Service Value:

5.Bearer Capability COS:

Connected to CC0 ON-LINE

enter command:

Figure 7-52.Procedure 321 Word 5: AAR-ISDN and Other Feature Parameters (Generic 2)

Field 1	Specifies the AAR pattern number. Permitted encodes are numbers within the
	range of 1 through 640.
Field 2	Specifies the AAR preference number. Permitted encodes are sequential numbers
	within the range of 1 through 16.
Field 3	Translates ISDN trunk type 120 only. Recall that for ISDN applications the trunk
	type may be translated as fixed (for example, one specific type) or dynamic (which
	may include those from the fixed category). Generally, the trunk type selected will
	depend on the network service/feature value, which is translated in field 4.
	Translates the ISDN trunk type. The network SERVICE application, and any
	associated application requirements, will determine the appropriate trunk type.
	Furthermore, trunk type selection should be coordinated with previous assignments
	from procedure 100, word 1.
Field 4	Specifies the network service requested. Refer to table 7-11,Network
	Services/Network Features, for the appropriate encode.