AT&T DS1/DMi/ISDN-PRI manual COS Default Capabilities, Call Types and Action Taken

ADMINISTRATION OPTIONS AND REQUIREMENTS — GENERIC 2 7-77

ENHANCED MODE - PROCEDURE: 014, WORD: 1

BEARER CAPABILITY CLASS OF SERVICE - CALL OPTIONS

1.	Bearer Capability	COS:	DEFAULT	CAPABILITIES
2.	Transport	Mode:	14.	Transport	Mode:
3.	Information	Type:	15.	Information	Type:
			16. Bearer Capability:

CALL TYPES AND ACTION TAKEN

4.Voice:

5.Voice Grade Data:

6.Mode 0:

7.Mode 1:

8.Mode 2:

9.Mode 3:

10.Unknown Digital:

11.Unknown Analog:

12.Mode 3/2:

13.X.25:

Connected to CC0 ON-LINE

enter command:

	Figure 7-36.Procedure 014 Word 1: BCCOS Routing Options
Field 1	Translates new (additional) BCCOS numbers. Field encodes and their descriptions
	are:
	● Dash (–)is used when the BCCOS does not support new numbers
	● Numbers between (0 and 255)
Field 2	Assigns the transport mode. Field encodes and their descriptions are:
	0 Circuit switch the call
	1 Packet switch the call
	2 Both circuit and packet
Field 3	Specifies whether the endpoint is unresticted (1) or restricted (0) with respect to
	incoming calls.
	It is the AAR/ARS software that routes calls. This software will block calls from an
	unrestricted type to a restricted type. As a contrast, the software will route calls
	from a restricted type to an unrestricted type. Furthermore, the software will route
	calls from restricted to restricted, depending on other attributes of the two BCCOS
	encodes.