AT&T DS1/DMi/ISDN-PRI manual Procedure 260 Word 1 DS1/DMI/ISDN-PRI Physical Interface

7-6ADMINISTRATION OPTIONS AND REQUIREMENTS — SYSTEM 85

Field 4	V1-V4
	Translates a particular type of carrier (such as DS1/MFAT, module control, or
	TMS) to the equipment location identified by fields 1-3. For DS1/DMI/ISDN-PRI
	applications the pertinent encodes are:
	4 TMS 0 control
	5 TMS 0 growth
	6 Module control 0
	7 Module control 1
	8 TMS 1 control
	9 TMS 1 growth
	11 DS1/MFAT port carrier
	Select a particular encode based on the intended purpose for translating this
	procedure, either to assign the SC or to assign a DS1/MFAT carrier.
Fields 5-10	V1-V4
	DS1/DMI/ISDN-PRI does not place any additional requirements on translating these
	fields.
Field 11	V1-V4
	Field encodes and their descriptions are:
	0 When the carrier (which is identified by fields 1-10) is not equipped with an SC.
	When an external synchronization clock is used, do not administer the SC. The
	SC software functions are replaced by the hardware/firmware contained within
	the external clock.
	1 When the carrier (module control or TMS) is equipped with an SC. The
	network synchronization plan should be available, and is required, to determine
	how to properly synchronize the switch.
Fields 12-15	V1-V4
	Not applicable for DS1/DMI/ISDN-PRI applications. Therefore, a dash (–) is
	appropriate.

Procedure 260 Word 1: DS1/DMI/ISDN-PRI Physical Interface

System 85 R2V3 DS1 administration software (procedure 260) contains all the same fields, options, and considerations as R2V1 and V2. Procedure 260 also provides a new field (14) for defining new application types for DS1 facilities. The R2V3 systems require the ANN11C, ANN11D, or ANN11E vintage circuit pack to provide the OPS line option. The ANN11D or ANN11E is required to provide the DMI-BOS option.