AT&T DS1/DMi/ISDN-PRI manual Procedure 103 Word 1 Network Trunk Group Translations

7-90	ADMINISTRATION OPTIONS AND REQUIREMENTS — GENERIC 2
Field 8	Assigns or not assign	the trunk group to SMDR record keeping. Field encodes and
	their descriptions are:

0 Trunk group usage not applicable for SMDR recording

1 Trunk group usage will be recorded by SMDR

2 Trunk group usage will be recorded, account code is required

Fields 9-11Not used for ISDN applications.

Field 12 This field is only applicable when SMDR is being used, and then only to change the default SMDR timer value. Field encodes represent intervals in 1-second increments. The range is 1 through 99 with dash (–) being the default timer value of 6 seconds.

Field 13 Administer the optional transmission loss assignments. The encode translated depends on the network configuration and service application. Field encodes and their corresponding loss plan are listed as follows:

0 The Digital FIXED Loss Plan

1 ISL Tie Trunk

2 EIA Tie Trunk

NOTE: This is the recommended option for Speedial Access Connections to a 4ESS.

3ISL Digital Central Office

4EIA Digital Central Office

5Digital Toll Office

6Analog Toll Office

7AUTOPLEX NETWORK Interface V

8AUTOPLEX NETWORK Interface Y

Refer to chapter 4, The Digital Loss Plan, for a description of the digital loss plan and to table 4-2,Digital Loss Plan (Port-to-Port Losses), in this same chapter for a list of port-to-port loss values.

Fields 14-16These fields are ignored by ISDN software. Either encode (0 or 1) is satisfactory.

Procedure 103 Word 1: Network Trunk Group Translations

This procedure is used to translate the trunk group network parameters. Figure 7-43,Procedure 103 Word 1: Network Trunk Group Translations, depicts this procedure.