AT&T DS1/DMi/ISDN-PRI manual Procedure 262 Word 3 ISDN-PRI Codeset Map Assignments, Fields

ADMINISTRATION OPTIONS AND REQUIREMENTS — GENERIC 2 7-69

Procedure 262 Word 3: ISDN-PRI Codeset Map Assignments

Depending on the terminating switch it may be necessary to administer a Codeset Map Assignment and convert from one codeset or codepoint to a different codeset or codepoint. This administration assignment is required for ISDN-PRI links originating on a Generic 2 and terminating on a System 85 R2V4. Figure 7-31, Procedure 262 Word 3: ISDN-PRI Codeset Map Assignments (Generic 2), depicts this procedure.

ENHANCED MODE - PROCEDURE: 262, WORD: 3

ISDN LINK PARAMETERS

EQUIPMENT LOCATION

1 . Module:

2 . Cabinet:

3 . Carrier:

4 . Slot:

5 . Circuit:

6.Codeset Map Number:

7.Hyperactivity Management:

Connected to CC0 ON-LINE

enter command:

Figure 7-31.Procedure 262 Word 3: ISDN-PRI Codeset Map Assignments (Generic 2)

Fields 1-4	Assigns a particular equipment location/circuit pack to be given a codeset map
	number. Table 7-8,Codeset Differences, depicts the permitted equipment ranges.
Field 5	Assigns whether the circuit pack is BRI or PRI. dash (–)is appropriate for ISDN-
	PRI.
Field 6	Assigns a codeset map number. The permitted range is (0 through 15). Number
	selection is arbitrary, however; a suggestion is start with 0 and select higher numbers
	as needed.
	When Codeset map numbers are translated they are assigned on a D-Channel Group
	number basis. All ISDN-PRI circuits within a D-Channel Group must be
	administered with the same Codeset Map Number.