7-54ADMINISTRATION OPTIONS AND REQUIREMENTS — GENERIC 2

Field 4

Fields 5-10

Field 11

Fields 12-15

Translates a particular type of carrier (such as DS1/MFAT, module control, or TMS) to the equipment location identified by fields 1-3. For DS1/DMI/ISDN-PRI applications, field encodes and their descriptions are:

2 Universal Module Control 0

3 Universal Module Control 1

4 TMS 0 Control

5 TMS 0 Growth

6 Traditional Module Control 0

7 Traditional Module Control 1

8TMS 1 Control

9TMS 1 Growth

10Universal port

11DS1 port carrier

Depending on whether the purpose for translating this procedure is to assign the SC or to assign a DS1 port carrier will determine which encode to select.

DS1/DMI/ISDN-PRI does not place any additional requirements on translating these fields.

Field encodes and their descriptions are:

0 Translated for external synchronization, when the carrier (which is identified by fields 1-10) is not equipped with an SC.

1 When the carrier (module control or TMS) is equipped with an SC.

NOTE: The network synchronization diagram should be available, and is required, to determine how to properly synchronized the switch.

Not applicable for DS1/DMI/ISDN-PRI applications. Therefore, a dash (–)is appropriate.

Procedure 260 Word 1: DS1/DMI/ISDN-PRI Physical Interface

Procedure 260 is required to administer each DS1. For traditional modules, the ANN11_ circuit pack provides DS1/DMI-BOS services while the ANN35 provides DMI-MOS/ISDN-PRI services. For universal modules, the TN767 circuit pack provides DS1/DMT services while the TN767/TN555 pair provides ISDN-PRI services. Figure 7-28,Procedure 260 Word 1: Additional DMI-MOS/ISDN- PRI Circuit Pack Assignments (Generic 2), depicts this procedure.

Page 190
Image 190
AT&T DS1/DMi/ISDN-PRI manual Field Fields, 54ADMINISTRATION Options and Requirements Generic