AT&T DS1/DMi/ISDN-PRI manual Procedure 108 Word 1 System 85 R2V4 & Generic, Field 11 Generic, Only

ADMINISTRATIVE PROCEDURE SUMMARY C-9

PROCEDURE 108 WORD 1 (System 85 R2V4 & Generic 2)

This procedure is used to assign the terminating test-line telephone digits to an ISDN-PRI trunk group. These are the address digits used to build the called party number IE in the setup message when making a demand test call via procedure 648 test 3. If digits are not translated, address digits do not appear in the IE.

The coding rules for the called party IE given in the Procedure 107 Word 1 section of this appendix also apply to this word.

PROCEDURE 116 WORD 1 (System 85 R2V4 & Generic 2)

This procedure is used to assign ISDN-PRI B-channels to trunk groups.

NOTE: Ensure that the interface endpoint field is assigned correctly for each B-channel.

Field 10 determines the encoding of the called party IE as discussed in the Procedure 107 Word 1 section of this appendix. If the B-channel is in an ISDN dynamic trunk group, this field determines how an incoming call over the trunk is processed (see the Procedure 100 Word 1 section earlier in this appendix).

Field 11 (Generic 2	Specifies the D-channel group associated with the channel. This information
only)	is used in constructing the channel identification IE.

PROCEDURE 210 WORD 2 (System 85 R2V4 & Generic 2)

Field 5 of this word is used to assign an NPA-NXX designator to an attendant console. If an attendant console is not assigned this designator, calls originated from this console over an ISDN-PRI trunk do not have a calling party number IE in the setup message. Likewise, calls terminating to this console over ISDN-PRI trunks do not have connected number EIs in the connect messages (see the Procedure 354 Word 3 section of this appendix).

PROCEDURE 260 WORD 1 (System 85 R2V4 & Generic 2)

This procedure is used to assign DS1 or ISDN characteristics to physical locations. Setting field 14 (application type) to 5 enables ISDN functionality for the specified physical location.

PROCEDURE 262 WORD 1 (System 85 R2V4 & Generic 2)

This procedure defines various ISDN board parameters. Default values are automatically assigned when a board is added in procedure 260 with an application type of ISDN-PRI.