AT&T DS1/DMi/ISDN-PRI manual Night, With auto Mode

7-124	ADMINISTRATION OPTIONS AND REQUIREMENTS — GENERIC 1
Port	This field associates each trunk group member to a particular network (1 or 2),
	carrier (A-E), slot (01-20), and circuit (01 -24). To keep things simple, try to match
	trunk group member and DS1 channel assignments (for example, trunk group
	member 1 on channel 1
Name	Typically, this entry is a 7-digit telephone number. However, another candidate
	would be the 10-digit trunk circuit identification number, which is available from
	the circuit provider.
Night	This is a new capability with Generic 1 and System 75, R1V3. It permits an
	individual trunk member to override the night		service option that is
	administered on page 1 of the TRUNK GROUP screen. Allowable entries are an
	extension, the attendant, or to leave blank if the Trunk Type field does not begin
	with auto/...
Mode	For DS1 tie trunk applications, the default and only permitted entry is e&m.
Type	For DS1/DMI applications, the default is T1	stan (T1 standard). Normally, this
	field is not administered. The default value	is	appropriate.

Ans Delay Allowable entries (in milliseconds) range from 20 to 5100 in intervals of 20. This should only be translated if delay-dial were optioned.

Processor Interface Data Module — ISDN-PRI Applications

Each ISDN-PRI circuit pack maintains the 24th channel as the D-signaling channel. For the switch processor to communicate with the D-signaling channel an administration link must be established between the processor and the D-channel. The procedure for establishing this link involves administering the following three screens:

●PROCESSOR INTERFACE DATA MODULE

●PROCESSOR CHANNEL ASSIGNMENTS

●INTERFACE LINKS

Figure 7-66,Data Module Screen, depicts this procedure.