AT&T DS1/DMi/ISDN-PRI manual Service or Facility Options, Can be assigned

ADMINISTRATION OPTIONS AND REQUIREMENTS — SYSTEM 85 7-7

System 85 R2V1 and V2 only provide trunks. However, R2V3 and V4 provide trunks, analog OPS lines, and DMI-BOS trunks. System 85 R2V4 (and later versions) provides DMI-MOS trunks; refer to table 7-1,DS1 Administration — Channel Versus Line Assignments.

Depending on the application type (encode) translated, there may be additional administration, slot, and port grouping restrictions.

Service or Facility Options

Procedure 260 is used to administer the DS1/DMI/ISDN-PRI Interfaces (ANN11B, ANN11C, ANN11D, ANN11E, or ANN35). Figure 7-4, Procedure 260 Word 1: System Configuration, Circuit Pack Assignments (System 85 R2V4), shows procedure 260, word 1.

ENHANCED MODE - PROCEDURE: 260, WORD: 1

DS1/ISDN AND RG CIRCUIT PACK ASSIGNMENTS

EQUIPMENT LOCATION		SC
1.	Module:	12.	Equipment Type:
2.	Cabinet:	13.	SC Reference:

3.Carrier:

4.	Slot:	14.	Application:
		15.	Bit Inversion:
SIGNALING		16.	Link Type:
6.	Framing:	17.	SA/FX:

7.PCS/CCS:

8.	24C/RBS	DISPLAY	ONLY:
9.	ZCS/B8ZCS:	18.	SC Information:

10.Slip Enable:

11.External Loop:

Connected to CC0 ON-LINE

enter command:

Figure 7-4.Procedure 260 Word 1: System Configuration, Circuit Pack Assignments (System 85 R2V4)

Fields 1-4	V1-V4
	Assigns the circuit pack to an equipment location. These assignments include the
	module number (0 through 30), cabinet number (0 through 7), DS1/MFAT carrier
	number (0 through 3), and slot number (5 or 18) for line plus trunk operation; or
	slot numbers (0, 5, 13, or 18) for line-only operation.
	System 85 R2V4 permits only trunk mode operation (that is, only slot numbers 5 or
	18 can be assigned).