Print Quality
Utilities
Calibrations
Accuracy
Recalibrate
Banding in all of the colors
1Make sure that the media selection made in the front panel is the same as the media that you have loaded.
2It is possible that the banding was caused because the customer was using
NOTE:If the customer wants to use HP certified paper at a later stage, they can restore the optimal setting to what it was by going to Utilities/Calibration/ Accuracy/Restore Factory.
3Perform the printheads alignment procedure.
Utilities
Calibrations
Printhead
Alignment
Full menu mode only
NOTE
The printhead alignment selection causes the printer to align the printheads immediately, or if an image is being printed, as soon as the current print job is finished. The alignment procedure requires a minimum paper size of A2 or
The printer will automatically perform an alignment when printheads are replaced. You can use this feature if the Print Quality Print indicates an alignment error.
You should not attempt to align the printheads with tracing paper, vellum or clear film.
If the banding problem remains after using HP Media and trying the above steps to resolve the problem, perform the Service Accuracy Calibration ⇒ Page
HP DesignJets 1050C and 1055CM Printers Service Manual |