Service Tests and Utilities
3If the test passes, then the following message will appear on the front panel:
ELECTRONIC SYSTEMS
|
| Tests passed | |
|
| FW: A.00.13 | |
|
| PS: 6.0A77R | |
|
| DIMM1: EDO 32MB 60ns | |
|
| DIMM2: EDO 16 MB 60ns | |
|
|
|
|
| IF THIS TEST PASSES, DO NOT REPLACE THE | ||
WARNING | |||
| ELECTRONICS MODULE, TRAILING CABLE OR THE | ||
| CARRIAGE ASSEMBLY. | ||
|
|
|
|
4If the test fails.
Electronics Failure
If there is a problem with the components within the Electronics module then the following message will appear on the front panel:
ELECTRONIC SYSTEMS
Possible Failure on:
1.Electronics Module
Code: 00XXXX:0000XX
In this case, Replace the Electronics Module ⇒ Page
DRAM Test Failure
If there is a problem with the DRAM then the following message will appear on the front panel:
ELECTRONIC SYSTEMS
Possible Failure on:
1.DRAM DIMMs
2.Electronics Module
Code: 00XXXX:0000XX
In this case, try one of the following:
1Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reseat the DRAM DIMMs (Memory Modules), reconnect the power cord and power On the Printer. Perform the Electronic Systems Test again.
HP DesignJets 1050C and 1055CM Printers Service Manual |