System Error Codes
System Error: | 06030B |
Problem | The Ambient Temperature measured is out of the normal range. |
Description: |
|
Corrective Action: | Try the following: |
| n Make sure that the Ambient temperature is within the allowed |
| range (between 0 and 55 Degrees Centigrade). |
| n Replace the Electronics Module ⇒ Page |
System Error:
Problem
Description:
Corrective Action:
NOTE
070100 XXXXXXXX
Firmware Error.
Power the Printer OFF and ON again to see if the System Error disappears.
If the Error Code reappears, then report the error to the HP response Center or the nearest HP Support Office, stating the following information.
nModel and Serial Number of the printer.
nWhich firmware revision the printer is using (See Note below). Check firmware in Utilities / Statistics / Code rev.
nThe complete error number (See Note below).
nThe Service Configuration Print ⇒ Page
nThe Current configuration sheet.
nWhich software application the customer is using (name, version, etc.).
When reporting the System Error Code, make sure that you supply the full Error Code (including the last 8 numbers where applicable) and the firmware version. Without this information, HP Support Personnel cannot help you.
HP DesignJets 1050C and 1055CM Printers Service Manual |