Removal and Installation
Right Hand Cover
| Refer to Figure 1 |
| Removal |
| 1. Remove the Printhead Cleaners (Refer to the User Guide). |
| Make sure that the Service Station Carriage is pushed to the |
NOTE | |
| back before trying to remove the Right Cover. |
| Switch off the printer and remove the power cable. |
| |
WARNING | |
1. | Remove the following: |
| 1. "Electronics Module Left Rear Cover" see page |
| Make sure you take care when removing the ferrite which is |
NOTE | |
| attached to the sideplate with a cable tie. |
|
|
2.Disconnect the front panel cable from position P16 FRONT PANEL on the electronics module.
3.Disconnect the aerosol fan cable from position P7 AEROSOL FAN on the electronics module.
4.Remove two
NOTE | Be careful not to drop the cover (item 3) once the securing |
| fasteners have been removed. Support the cover throughout the |
| next step. |
|
|
5.Remove two
6.Remove the right hand cover (item 3) by making sure you:
a carefully pull the front panel cable and the aerosol fan cable from a hole in the right hand side chassis.
b disconnect the service station door sensor cable, which hangs down from the service station cable.
HP DesignJets 1050C and 1055CM Printers Service Manual |