Removal and Installation
Air Pressurization System (APS)
Removal
WARNING | Switch off the printer and remove the power cord. | |
1. | Remove the Ink Cartridges (Refer to the User Guide). | |
2. | Remove the following: | |
| 1. | "Left Hand Cover" see page |
| 2. | "Ink Supply System" see page |
| When removing the APS from the ISS, take care with the tube | |
NOTE | ||
| and cables attached to the ISS. | |
|
|
|
3.Release the APS from the retaining clips underneath the ISS as shown in Figure 18.
NOTE | If ink in the air system is suspected (Ink Cartridge leakage or |
| depressurization System Error), be very careful when removing |
| the APS because there could be ink in the APS. |
|
|
Release from these clips
| C607443 |
| Figure 18: Air Pressurization System |
| Installation of the Air Pressurization System (APS) |
| When assembling the APS, make sure that the air tube is correctly |
| routed and not pinched. |
| Perform the Ink Pressure System Test (⇒ Page |
NOTE | |
| reinstalling the APS to make sure that it functions correctly. |
|
|
HP DesignJets 1050C and 1055CM Printers Service Manual |