System Error Codes

System Error: 0C0032 (Continuable)

ProblemDrop Detector not Calibrated for all Printheads.

Description:

Corrective Action: Try the following:

nPerform the Service Station Calibration ⇒ Page 5-11.

nReplace the Drop Detector Assembly ⇒ Page 8-10.

nIf the Error Code continues, replace the Electronics Module ⇒ Page 8-25.

WARNING

System Error:

Problem

Description:

Corrective Action:

System Error:

Problem

Description:

Corrective Action:

WARNING

Only replace one component at a time and check if the error has gone before replacing another component. Using this procedure you will be able to determine exactly which component failed.

0C1000

Primer not Calibrated.

Try the following:

nPerform the Service Station Calibration ⇒ Page 5-11.

nMake sure that the Primer Arm is not damaged. If the Primer Arm is damaged, replace the Service Station ⇒ Page 8-8.

nReplace the Electronics Module ⇒ Page 8-25.

0C1001

Primer Shutdown Error.

Try the following:

nCheck that the Primer Stepper-Motor Cable is NOT broken or damaged and that the Primer arm moves freely from side to side.

nReplace the Service Station ⇒ Page 8-8.

nIf the Error Code continues, replace the Electronics Module ⇒ Page 8-25.

Only replace one component at a time and check if the error has gone before replacing another component. Using this procedure you will be able to determine exactly which component failed.

HP DesignJets 1050C and 1055CM Printers Service Manual

2-17