Removal and Installation
3.When installing the belt, make sure it is not twisted and is installed in the correct orientation as shown in Figure 51.
Installed in the direction of the
| Installed in the direction |
| of the Tensioner Assembly |
| C607442 |
| Figure 51: Belt Installation |
NOTE | You must perform the following Service Calibrations after the |
| installation of the Carriage Assembly. |
nCarriage Height Calibration ⇒ Page
nLine Sensor ⇒ Page
nService Station ⇒ Page
nRoller Mark Position ⇒ Page
nColor to Color Calibration ⇒ Page
nPen Alignment ⇒ Page
HP DesignJets 1050C and 1055CM Printers Service Manual |