Removal and Installation
NOTE | For the following steps, refer to Figure 37. |
6.Remove the
7.Remove two
WARNING | Be very careful when disconnecting the Trailing Cable from the |
| Electronics Module. Incorrect handling will damage the Trailing |
| Cable and then it will need replacing. |
|
|
8.Carefully disconnect the trailing cable from the electronics module and pull the trailing cable away from the printer.
3
4
2
1
| C607413 |
| Figure 37: Trailing Cable |
| Installation of the Trailing Cable |
WARNING | When reconnecting the Trailing Cable to the Electronics |
| Module, make sure you connect it correctly as follows: |
1.Start reconnecting the Trailing Cable from left to right (the longest strip will be connected to the 1st clip from the right).
2.Make sure you push the Trailing Cable in straight and not bent. Once the Trailing Cable is inserted, you should hear an audible click.
HP DesignJets 1050C and 1055CM Printers Service Manual |