System Error Codes
System Error: | 0A0070 (Continuable) |
Problem | The Backup EEROM contents stored in the Tubes System are not |
Description: | consistent with the ones required by the firmware. |
Corrective Action: | Try the following: |
| n Perform the Calibrations Backup ⇒ Page |
NOTE
System Error:
Problem
Description:
Corrective Action:
WARNING
Make sure that you select "Tubes Replaced" when performing the Calibrations Backup.
0C0030
Bad Drop Detector.
Try the following:
nCheck that the Drop Detector Cable is NOT broken or damaged.
nCheck that the Drop Detector cable is correctly connected to the Service Station Cable.
nRemove the Drop Detector and make sure that there are no obstacles inside which are blocking the sensor.
nReplace the Drop Detector Assembly ⇒ Page
nIf the Error Code continues, replace the Electronics Module ⇒ Page
Only replace one component at a time and check if the error has gone before replacing another component. Using this procedure you will be able to determine exactly which component failed.
HP DesignJets 1050C and 1055CM Printers Service Manual |