Removal and Installation
NOTE | For steps 11 and 12, refer to Figure 46. |
11.Remove the 5.5mm nut (item 1) from the left side of the Printer that attaches the Encoder Strip (item 3) to Spring Clip (item 2).
NOTE | To perform the next step use a screw driver to press the spring |
| clip (item 2) in towards the middle of the printer. |
|
|
12.Release the Encoder Strip (item 3) from the retaining pin (item 4) on the Spring Clip (item 2).
3
4
1 | 2 | C60710 |
|
Figure 46: Encoder Strip
HP DesignJets 1050C and 1055CM Printers Service Manual |