Removal and Installation
NOTE | For steps 3 and 4, refer to Figure 39 |
3.Loosen the retaining screw
4.Remove the printhead tube connector (refer to Figure 39).
View from the rear
c. Loosen this screw
a. Push in here
a. Push in here
b. Pull here
Printhead tube connector
Figure 39: Cutter Assembly
5.Move the Printhead tube connector to a safe position.
NOTE | For the following steps, refer to Figure 40. |
6.Remove one screw (item 1) and washer (item 2) that attaches the Cutter Assembly (item 3) to the Carriage Assembly (item 4).
7.Slide the Cutter Assembly (item 3) towards you and remove from the Printer.
4
1
2
3
C607417a
Figure 40: Cutter Assembly
HP DesignJets 1050C and 1055CM Printers Service Manual |