System Error Codes
System Error: | 0B0006 |
Problem | The Trailing Cable has been incorrectly connected OR the fuse in |
Description: | the Electronics Module has been burned. |
Corrective Action: | Turn the Printer OFF and disconnect the trailing cable. Check that |
| the ends of the Trailing Cable are flat and are not damaged or bent. |
| Reconnect the Trailing Cable correctly, making sure it is pushed in |
| firmly (Refer to the instructions on Page |
| Printer and check if the Error Code disappears. If the Error Code |
| continues, replace the Electronics Module (Refer to the instructions |
| on Page |
| Trailing Cable. |
WARNING
PLEASE TAKE CARE WHEN CONNECTING THE TRAILING CABLE TO THE ELECTRONICS MODULE. INCORRECT INSTALLATION WILL BURN THE FUSE IN THE ELECTRONICS MODULE, CAUSING THE COMPLETE REPLACEMENT OF THE ELECTRONICS MODULE.
System Error: | 0B0007 |
Problem | Unable to detect Vacuum Fan. |
Description: |
|
Corrective Action: | Try the following: |
| n Make sure that the Vacuum Fan is connected correctly to the |
| Electronics Module. |
| n Turn the Printer OFF and disconnect the Vacuum Fan from the |
| Electronics Module. Connect a New Vacuum Fan to the |
| Electronics Module and power ON the Printer. If the New Vacuum |
| Fan functions correctly without any Error Codes then remove the |
| Old Vacuum Fan from the Printer and install the New one. |
| n If the New Vacuum Fan does not function correctly either, then |
| replace the Electronics Module ⇒ Page |
System Error: | 0B0008 |
Problem | Unable to detect Cooling Fan. |
Description: |
|
Corrective Action: | Replace the Electronics Module ⇒ Page |
HP DesignJets 1050C and 1055CM Printers Service Manual |