Removal and Installation
Encoder Strip
Refer to Figure 30 to Figure 32.
Removal
WARNING | Switch off the printer and remove the power cord. | |
1. | Remove the following | |
| 1. | "Left Hand Cover" see page |
| 2. | "Right Hand Cover" see page |
| 3. | "Back Cover" see page |
CAUTION
NOTE
NOTE
2.
3.
To prevent damage to the encoder strip, hold it at the ends only.
Working from the rear of the printer.
For steps 2 and 3, refer to Figure 30.
Remove five 7mm nuts (item 1) from the EMC Cover (item 2).
Remove two
1
2
3
3 | C607409 |
Figure 30: Encoder Strip
HP DesignJets 1050C and 1055CM Printers Service Manual |