Removal and Installation
CAUTION | The complete ink tube system is full of ink. |
15.Now you can remove the complete Tubes System from the printer by sliding the tubes from between the tube guides.
Restarting the printer1Turn the printer ON from the main power switch at the rear of the printer and from the power switch on the front panel.
2.The front panel displays:
System StartupSystem Startup
Press Enter to Continue
C4704034
3.Press the Enter button.
4.Lift up the window and install four setup printheads into the Printhead carriage. (Refer to the User’s Guide for details).
5.Install the Ink Cartridges. (Refer to the User’s Guide for details).
6.The front panel displays:
|
| InitializingSystemprinterStartup |
|
|
| WaitPress Enter to Continue |
|
|
| C4704034 |
|
7. | Wait for about 30 seconds. | ||
8. | Remove the setup printheads from the printer carriage. | ||
9. | Install the Printheads and the Printhead Cleaners (Refer to the | ||
| User’s Guide for details). | ||
| You must perform the following Service Calibrations after the | ||
NOTE | |||
| installation of the Tubes System. | ||
|
|
|
|
n Calibrations Backup ⇒ Page
n Pen Alignment ⇒ Page
HP DesignJets 1050C and 1055CM Printers Service Manual |