Removal and Installation

NOTE

For the following steps, refer to Figure 20.

6.Remove the two T-10 screws (item 1) from the left roller gear (item

2)attached to the left side of the roller.

7.Remove the two T-20 screws (item 3) from the roller support (item

4)and remove the support.

8.Release the tension from the torsion spring (item 5) by removing the arm of the spring off the spring hook (item 6).

9.Remove the two T-15 screws (item 7) from the pinch sensor bracket (item 8) and remove the bracket with the sensor attached. Release the sensor cable from retaining clips to remove completely.

10.Remove the spring hook (T-15) (item 6).

1*

3*

4*

1*

3*

5

2*

7

*These items do not need to be removed when removing the Paper Entry Assembly or the Center Guide

6

7

8

7

C607420b

Figure 20: Miscellaneous Parts

8-22

HP DesignJets 1050C and 1055CM Printers Service Manual