System Error Codes
System Error: | 060309 |
Problem | Problem with setting the Voltage of the Printheads. |
Description: |
|
Corrective Action: | Try the following: |
| n Remove ALL the Printheads and clean the flex contacts on the |
| Printheads and in the Carriage Assembly (Refer to Chapter 2). |
| n Perform the Electronic Systems Test ⇒ Page |
| n Replace ALL the Printheads. |
| n Replace the Trailing Cable ⇒ Page |
| n Replace the Carriage Assembly ⇒ Page |
| n If the Error Code continues, replace the Electronics Module ⇒ |
| Page |
WARNING
System Error:
Problem
Description:
Corrective Action:
Only replace one component at a time and check if the error has gone before replacing another component. Using this procedure you will be able to determine exactly which component failed.
06030A (Continuable)
Error in finding the Mark Encoder.
Try the following:
n Clean the Mark Encoder if necessary (use the Overdrive Cleaning Utility to position the Mark Encoder ⇒ Page
| n Clean the Line Sensor (located on the Carriage Assembly). |
| n Perform the Line Sensor Calibration ⇒ Page |
| n Perform the Mark Encoder Calibration ⇒ Page |
| n Replace the Trailing Cable ⇒ Page |
| n Replace the Carriage Assembly ⇒ Page |
| n If the Error Code continues, replace the Electronics Module ⇒ |
| Page |
| Only replace one component at a time and check if the error has |
WARNING | |
| gone before replacing another component. Using this procedure |
| you will be able to determine exactly which component failed. |
|
|
HP DesignJets 1050C and 1055CM Printers Service Manual |