Service Calibrations
Service CalibrationsThe following is a list of all internal service calibrations available in the Printers. Instructions for entering the service calibrations menu are given on Page
1Accuracy Calibration ⇒ Page
The purpose of this Service Calibration is to calibrate the nominal advance of the media. This calibration is necessary to control the exact movement of the media in order to avoid print quality problems like banding.
2Line Sensor ⇒ Page
The purpose of this Service Calibration is to calibrate the intensity of the line sensor in the Carriage PCA. An incorrect calibration can result in
3Service Station ⇒ Page
The purpose of this Service Calibration is to calibrate the Service Station in relation to the Carriage Assembly.
4Roller Mark Position ⇒ Page
The purpose of this Service Calibration is to calibrate the Mark Encoder which is located on the Drive Roller.
5Pen to Paper Spacing ⇒ Page
THIS CALIBRATION IS NO LONGER REQUIRED.
6Color to Color Calibration ⇒ Page
The purpose of this Service Calibration is to correct the alignment between the Printheads and the rest of the Printer. This calibration is necessary in order to prevent color misalignment.
7Calibrations Backup ⇒ Page
The purpose of this Service Calibration is to allow the EEROM contents to be saved when the Electronics Module or the Tubes System is replaced.
8Pen Alignment ⇒ Page
The purpose of this Service Calibration is to correct the alignment between the Printheads. This calibration is necessary in order to prevent color misalignment and print quality defects like banding.
uCarriage Height Calibration ⇒ Page
The purpose of this Service Calibration is to adjust the distance between the Carriage and the Center Platen. This calibration is necessary in order to prevent problems like Printhead crashes.
HP DesignJets 1050C and 1055CM Printers Service Manual |