Service Calibrations
3If you selected to continue, then the following message appears on the front panel if media is not loaded. You must load Media in to the Printer to continue.
Please, load paper to perform this operation and try again
Press ENTER to continue
Top |
|
Back |
|
− |
|
↓ |
|
Enter | Press Enter |
4The Printer will start to print the Line Sensor Pattern and the following message will be displayed on the front panel:
Calibrating line sensor.
Please wait.
5Once the line sensor calibration is completed, the following message will be displayed on the front panel:
Top
Line sensor calibrated. | Back |
|
|
|
| − |
|
|
|
|
|
|
| |
Press ENTER to continue |
| ↓ |
| Press Enter | |
|
| ||||
| Enter |
| |||
|
|
|
| ||
| |||||
|
|
|
| ||
|
|
|
|
|
|
6To check if the Calibration was completed correctly, print the Service Configuration Print (see Page
Check that these value are NOT zero
7If the calibration fails Perform the Electronic Systems Test ⇒ Page
HP DesignJets 1050C and 1055CM Printers Service Manual |