Removal and Installation

Electronics Module

Refer to Figure 23 and Figure 24.

Removal

WARNING

Switch off the printer and remove the power cord.

 

Working from the rear of the Printer.

NOTE

 

 

1.

Remove the following:

 

1.

"Left and Right Hand Rear Covers" see page 8-24.

 

2.

"Tail Deflectors and Rear Platen" see page 8-23.

 

For steps 2 to 7, refer to Figure 23.

NOTE

 

 

 

2.Locate the four T-10 screws (item 1) that secure the DIMM cover (item 2) to the Electronics Module. Remove the four screws and the DIMM cover.

Note the position of the DIMMs. From left to right:

n The DRAM DIMM(s) are held in the 1st and 2nd slot (item 3).

n The Firmware/Postscript Code DIMM (Flash DIMM) are held in the 3rd slot (Item 4).

3.Remove the DIMMs by releasing the retaining clips at the top and bottom of each one, holding the outer non-metallic edge and gently pulling towards you. Store these parts in a safe place.

4.With a flat end screwdriver, unscrew the two screws that attach the EIO card (item 5) to the Electronics Module. Remove the EIO card and store in a safe place.

5.With a flat end screwdriver, unscrew the two screws that attach the Hard Disk Drive (item 6) to the Electronics Module. Remove the Hard Disk Drive and store in a safe place.

WARNING

Be very careful when disconnecting the Trailing Cable from the

 

Electronics Module. Incorrect handling will damage the Trailing

 

Cable and then it will need replacing.

 

 

6.Disconnect the Trailing Cable by releasing it from retaining clips in the socket and carefully pulling it towards you.

7.Carefully disconnect all the cables from the left and right side of the electronics module.

HP DesignJets 1050C and 1055CM Printers Service Manual

8-25