Service Tests and Utilities
NOTE
NOTE
WARNING
Tip for Repair
The purpose of this test is to verify the operation of the:
nElectronics Module.
nDRAM.
nTrailing Cable.
nCarriage Assembly.
This test does not test the EIO Card or the Hard Disk Drive.
The Service Tests work in a special Mode which does NOT require the full Initialization of the Printer. Therefore it is important that once you have finished with the Service Test, you MUST power OFF the Printer and Power ON again before trying to print.
IF POSSIBLE ALWAYS PERFORM THIS TEST BEFORE REPLACING THE ELECTRONICS MODULE, TRAILING CABLE OR THE CARRIAGE ASSEMBLY. IF THIS TEST PASSES, DO NOT REPLACE THE ELECTRONICS MODULE, TRAILING CABLE OR THE CARRIAGE ASSEMBLY.
This test can be performed with just the Front Panel, Trailing Cable, Carriage, Electronics Module and the Power Cord connected together to isolate problems.
HP DesignJets 1050C and 1055CM Printers Service Manual |