Service Calibrations
3If you selected to continue, then the following message appears on the front panel if media is not loaded. You must load Media in to the Printer to continue.
Please, load paper to perform this operation and try again
Press ENTER to continue
Top
Back
−
↓
Enter |
| Press Enter |
|
4The Printer will start to print the calibration pattern and the following messages will be displayed on the front panel:
Performing service position calibration.
Please wait.
Performing drop detector calibration.
Please wait.
| Performing primer |
|
|
|
|
| Performing platen |
|
| calibration. |
|
|
|
|
| distance calibration. |
|
| Please wait. |
|
|
|
|
| Please wait. |
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
5Once the service station calibration is completed, the following message will be displayed on the front panel:
|
|
|
|
| Top |
|
|
| Service station |
|
|
| Back |
|
|
| calibration |
|
|
|
|
| |
| finished. |
|
|
| − |
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
| |
| Press ENTER to continue |
|
|
| ↓ |
| Press Enter |
|
|
|
|
| |||
|
|
|
| Enter |
| ||
|
|
|
|
| |||
|
|
|
|
|
|
6To check if the Calibration was completed correctly, print the Service Configuration Print (see Page
Check that the Calibrations are done and within the limits
HP DesignJets 1050C and 1055CM Printers Service Manual |