Removal and Installation
Drive Roller
Refer to the Figure 77.
Removal
WARNING | Switch off the printer and remove the power cord. | |
1. | Remove the following: | |
| 1. | "Clutch Assembly" see page |
| 2. | "Roller Guide" see page |
| Working from the rear of the printer. | |
NOTE | ||
|
|
|
2.Remove the roller (item 1) as follows:
a Pull the left side of the roller towards you and then pull the right side of the roller towards you
b Move the complete roller to the left.
c Remove the right side of the roller first and then the left side.
3
| C607431a |
| Figure 77: Drive Roller |
| You must perform the following Service Calibrations after the |
NOTE | |
| installation of the Drive Roller. |
| n Accuracy Calibration ⇒ Page |
| |
| n Color to Color Calibration ⇒ Page |
HP DesignJets 1050C and 1055CM Printers Service Manual |