ADMINISTRATION OPTIONS AND REQUIREMENTS — GENERIC 2

7-53

 

 

 

 

Procedure 250 Word 1: SC/DS1 — Carrier Designation

This procedure is used to assign the equipment carriers to a module and cabinet. Additionally, it is used to assign the type of carrier, the carrier port electrical number, and whether the carrier is equipped with an SC. Figure 7-27, Procedure 250 Word 1: System Configuration — Carriers (Generic 2), depicts this procedure.

ENHANCED MODE - PROCEDURE: 250, WORD: 1

 

 

CARRIERS

 

CARRIER

LOCATION

LOCAL

RMI LOCATION

1.

Module:

12.

Module:

2. Cabinet:

13.

Cabinet:

3. Carrier:

14. Carrier:

 

 

15.

Slot:

4. Carrier Type:

 

 

MODULE CONTROL

5.I/O:

6.PDS:

7.Duplicated:

8.TMS:

9.Port Electrical Carrier:

10.TMS Electrical Carrier:

11.SC Equipped:

Connected to CC0 ON-LINE

enter command:

Figure 7-27.Procedure 250 Word 1: System Configuration — Carriers (Generic 2)

DS1 circuit packs may only be installed within DS1 port carriers. Each Generic 2 that is equipped with one or more DS1s will also contain either a TN463 synchronization clock (SC) or a TN2131C. For single-module systems, the SC is located in the module control carrier along with the TN460 module clock. For multimodule systems, the SC is located in the TMS carrier.

Fields 1-3Identifies a module number, cabinet number, and physical carrier position. The appropriate encodes are determined based on whether the module is traditional or universal and the physical equipment location, refer to table 7-6,Equipment Parameters and Permitted Translation Encodes.

Page 189
Image 189
AT&T DS1/DMi/ISDN-PRI manual Procedure 250 Word 1 SC/DS1 Carrier Designation, Module Control