2-6NETWORK CONNECTIONS AND CONFIGURATIONS

DS1/DMI PUBLIC-NETWORK CONNECTIONS

Public-network connections may include connections to COs, DACS frames, and toll offices.

4ESS to Another System (Special-Access Connection)

Connections to a 4ESS switch are called special-access connections. The physical connection is made directly from customer premises to the 4ESS. Toll calls go directly from a System 75, System 85, Generic 1, or Generic 2 to the AT&T toll network.

The physical connection to a 4ESS toll switch is made (through the digital interface frame, or DIF) to a SM9 circuit pack.

With a 4ESS, several suggestions are applicable for the special-access connection. These suggestions and how they apply are described below.

Framing, Signaling, and Line Coding

A 4ESS provides the option of selecting either D4 or ESF framing, ZCS or B8ZS line coding, and either robbed-bit signaling or ISDN-PRI.

E&M or Reverse-Battery Signaling

A 4ESS has been used traditionally in a class-4 or higher toll office and was not initially designed to support lines. A 4ESS can only provide E&M and reverse-battery signaling. For DS1/DMI-BOS, these signals are identical to E&M signaling. Therefore, all trunks (channels) terminating on a 4ESS should be administered as either E&M or Direct Inward Dialing (DID) trunk type. (Refer to Special Access Connections to the AT&T Communications Network for New Service Applications (326-204) for more information.) The following options are applicable for these connections:

E&M both one-way and two-way operation; either immediate start, wink start, or delay dial

Reverse-batteryone-way incoming, either immediate start or wink start.

Dial Tone

Second dial tone may be provided by a 4ESS. However, it is recommended that a System 75, System 85, Generic 1, or Generic 2 tone plant be used to provide a second dial tone. With this arrangement, the second dial tone can be provided through use of the Automatic Route Selection (ARS) feature on all DS1/DMI-BOS trunks that terminate on a 4ESS.

Touch-Tone Capability

A 4ESS supports dual-tone multifrequency signaling (DTMF).

Page 62
Image 62
AT&T DS1/DMi/ISDN-PRI manual DS1/DMI PUBLIC-NETWORK Connections, 4ESS to Another System Special-Access Connection