AT&T DS1/DMi/ISDN-PRI manual Appendixes, Abbreviations Glossary Index, About this Document

ABOUT THIS DOCUMENT xxi

6.PORT TYPES/INSTALLATION COMPATIBILITIES — Describes the DS1/DMI circuit pack operating modes, slot restrictions, and administration considerations and restrictions. This section also includes a table that lists the available port types and shows their compatibility on a system, release, version, and circuit-pack suffix basis.

7. ADMINISTRATION OPTIONS AND REQUIREMENTS — Covers the following information:

—Describes those procedures that are required for DS1 services, what the available field encode options are, and the considerations for choosing the options for System 85

—Describes those procedures that are required for DS1 services, what the available field encode options are, and the considerations for choosing the options for DEFINITY Generic 2

—Describes the administration screens that are required for DS1 services, any unusual or special field requirements or considerations, and options for System 75 and System 75XE

—Describes the administration screens that are required for DS1 services, any unusual or special field requirements or considerations, and options for Generic 1

8.MAINTENANCE AND ALARMS — Describes the diagnostic capabilities and alarms provided by DS1/DMI/ISDN-PRI. This part also provides information on methods of alarm analysis and alarm resolution.

●APPENDIXES

A.ADMINISTRATION REQUIREMENTS — Provides screens showing administration field examples for System 75 (RlV2 and R1V3) special-access connections.

B.SAMPLE INSTALLATION AND MAINTENANCE PROBLEMS — Describes, with examples, some of the more typical field problems, such as translation-based, synchronization-related, and physical-interface connection problems.

C.ADMINISTRATIVE PROCEDURE SUMMARY — Describes the administrative procedures used on DEFINITY Generic 2 that relate to the ISDN-PRI, including how pertinent administrative fields relate to ISDN-PRI level 3 message contents and general feature operation.

D.TRUNK TYPE AND SIGNALING TYPE COMPATIBILITY TABLES — Provides tables that define trunk type to signaling type compatibility for System 85 R2V1, R2V2, R2V3, R2V4, and Generic 2.

●ABBREVIATIONS

●GLOSSARY

●INDEX

NOTE: Although this document applies specifically to DS1/DMI and to ISDN-PRI, the Generic 2 Remote Group Interface (RGI) is also a DS1 application. As such, portions of chapter 1, Introduction, chapter 3, DS1 Transmission and Cabling, chapter 4, The Digital Loss Plan, and chapter 8, Maintenance and Alarms, may also apply in a general sense to the RGI. Specific information on the RGI is provided in documents on that subject.