AT&T DS1/DMi/ISDN-PRI manual Field 1 Field

ADMINISTRATION OPTIONS AND REQUIREMENTS — SYSTEM 85 7-31

ENHANCED MODE - PROCEDURE: 101, WORD: 1

						TRUNK	GROUP CHARACTERISTICS
1.				Trunk	Group:		15.	APLT Features Allowed:
2.	Balance:						16.	Disconnect Supervision:
3.			Battery Reversal:				17.	AVD:
4.	Incoming			Prefix	Digit:
5.	DCS:
6.				Touch-Tone In:
7.			Touch-Tone			Out:
8.				SMDR	Active:
9.		AIOD		Billing	Number:
TIMED		RECALL
10.			Time:
11. Level:
12.			SMDR	Variable		Timer:
13.	Pad		Group:
14. Tie			Toll:
Connected to CC0 ON-LINE
enter		command:

Figure 7-13.Procedure 101 Word 1: Additional Trunk Group Translations (System 85 R2V4)

Field 1 Field 2

Displays the trunk group number, such as previously translated in procedure 100.

Selects whether the trunk group uses balanced transmission facilities. Field encodes and their descriptions are:

0Not provided — the required option for ISDN-PRI.

1Provided — not applicable for ISDN-PRI.

Field 3	Translates the battery reversal option. Field encodes and their descriptions are:
	0	Not provided — the required option for ISDN-PRI
	1	Provided — not applicable for ISDN-PRI
Field 4	Depending on how each type of DID service is provisioned it may or may not be
	necessary for the switch to infer (generate) a digit to complete the call. Field
	encodes and their descriptions are:

●Dash (–)is applicable for all ISDN-PRI applications except DID (trunk types 30, 31, and 120).

●Any single digit number (0 through 9). Which number is determined by the trunk group and its application.

NOTE: When using System 85 R2V4 1.1 software, digits cannot be inferred for ISDN-dynamic trunk types.

Field 5 Assigns whether the trunk group is (1) or is not (0) used for DCS applications.