Baldor mn722 Input Operating Mode, Keypad Standard RUN, Potentiometer, Volts, ANA CMD Inverse

	Table A-2 Power Output Parameter Block Values Level 1			Continued
		Level 1 Blocks - Continued
Block Title	Parameter	P#	Adjustable Range	Factory	User
					Setting
INPUT	OPERATING MODE	1401	1– KEYPAD	KEYPAD
			2– STANDARD RUN
			3– 15SPD
			4– 3SPD ANA 2WIRE
			5– 3SPD ANA 3WIRE
			6– SERIAL
			7– BIPOLAR
			8– PROCESS MODE
			9– EPOT –2WIRE
			10– EPOT –3WIRE
	COMMAND SELECT	1402	0– POTENTIOMETER	+/-10
			1– +/-10 VOLTS	VOLTS
			2– +/-5 VOLTS
			3– 4 To 20 mA
			4– 10V W/TORQ FF
			5– EXB PULSE FOL
			6– 5VOLT EXB
			7– 10 VOLT EXB
			8– 4-20mA EXB
			9– 3-15 PSI EXB
			10– TACHOMETER EXB
			11– SERIAL
			12– NONE
	ANA CMD INVERSE	1403	0–OFF, 1– ON	OFF
	ANA CMD OFFSET	1404	-20.0 TO +20.0%	0.0 %
			(where ± 0.5V=± 20%)
	ANA 2 DEADBAND	1405	0-10.00 V	0.00 V
	ANA 1 CUR LIMIT	1406	0–OFF, 1– ON	OFF
OUTPUT	OPTO OUTPUT #1	1501	0– READY	READY
			1– ZERO SPEED
			2– AT SPEED
			3– OVERLOAD
	OPTO OUTPUT #2	1502	4– KEYPAD CONTROL	ZERO
			5– AT SET SPEED	SPEED
			6– FAULT
			7– FOLLOWING ERR
			8– MOTR DIRECTION
	OPTO OUTPUT #3	1503		AT SPEED
			9– DRIVE ON
			10– CMD DIRECTION
			11– AT POSITION
			12– OVER TEMP WARN
	OPTO OUTPUT #4	1504		FAULT
			13– PROCESS ERROR
			14– DRIVE RUN
			15– SERIAL
	ZERO SPD SET PT	1505	1-MAX Speed	200 RPM
	AT SPEED BAND	1506	1-1000 RPM	100 RPM
	SET SPEED	1507	0-MAX Speed	Rated Motor
				Speed

MN722 Appendix A-3