Baldor mn722 manual Converter Control Board Jumper, Inverter Control Board Jumper

Control Board Jumpers

Converter Section Control Board

Figure 3-10 Converter Control Board Jumper JP1 Location

Expansion Board Motor Control Board

Keypad

Connector

		3 2 1		JP1
				See recommended terminal tightening
				torques in Section 7.
	Table 3-9 Converter Control Board Jumper
Jumper	Jumper Position		Description of Jumper Position Setting
JP1	1–2	Voltage Speed Command Signal. (Factory Setting)
	2–3	4–20mA Speed Command Signal.

Inverter Section Control Board

Figure 3-11 Inverter Control Board Jumper Locations

JP2

1 2 3

Refer to Table 3-10

for jumper placement information.

1 2 3

JP1

		See recommended terminal tightening torques in Section 7.
	Table 3-10	Inverter Control Board Jumper
Jumper	Jumper Position	Description of Jumper Position Setting
JP1	1-2	Voltage Speed Command Signal. (Factory Setting)
	2-3	4-20mA input at Analog #2
JP2	1-2	Factory Setting
	2-3	Not used.

3-18 Receiving & Installation MN722