Program Mode

Continued

 

 

 

Changing Parameter Values when Security Code Not Used

 

 

 

Use the following procedure to program or change a parameter already programmed into

 

 

the control when a security code is not being used.

 

 

 

The example shown changes the operating mode from Keypad to Bipolar.

 

 

 

 

 

 

 

 

Action

 

Description

 

Display

Comments

 

 

 

 

 

 

 

 

Apply Power

 

Keypad Display shows this

 

 

 

Logo display for 5 seconds.

 

 

 

 

 

opening message.

 

 

 

 

 

 

If no faults and programmed for

 

 

 

 

Display mode. Stop LED on.

 

 

 

 

 

 

 

 

 

 

 

LOCAL operation.

 

 

 

 

Press PROG key

 

Access programming mode.

 

 

 

 

Press ENTER to access INPUT

 

 

 

 

 

 

 

Press Y or B key

 

Scroll to Level 1 Input Block.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

block parameter.

Press ENTER key

 

Access Input Block.

 

 

 

 

Keypad mode shown is the

 

 

 

 

 

 

 

 

 

 

 

 

 

 

factory setting.

Press ENTER key

 

Access Operating Mode

 

 

 

 

Keypad mode shown is the

 

 

 

 

 

 

 

 

 

parameter.

 

 

 

factory setting.

Press Y key

 

Scroll to change selection.

 

 

 

 

At flashing cursor, select desired

 

 

 

 

 

 

 

 

 

 

 

 

 

 

mode, BIPOLAR in this case.

Press ENTER

 

Save selection to memory.

 

 

 

 

Press ENTER to save selection.

 

 

 

 

 

 

 

 

 

Press Y key

 

Scroll to menu exit.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Press ENTER key

 

Return to Input Block.

 

 

 

 

 

 

 

 

 

 

 

 

 

Press DISP key

 

Return to Display Mode.

 

 

 

Typical display mode.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

MN722

Programming & Operation 4-7

Page 54
Image 54
Baldor mn722 manual Changing Parameter Values when Security Code Not Used, Program Mode