Baldor mn722 manual Reset Parameters to Factory Settings

Program Mode	Continued
Reset Parameters to Factory Settings
		Sometimes it is necessary to restore the parameter values to the factory settings. Follow
		this procedure to do so. Be sure to change the Level 2 Motor Data block “Motor Rated
		Amps” to the correct value after this procedure (restored factory setting is 999).
		Note: All specific application parameters already programmed will be lost when
		resetting the control to factory settings.
		Note: After factory settings are restored, the drive must be re-tuned.
Action		Description	Display	Comments
Apply Power		Keypad Display shows this		Logo display for 5 seconds.
		opening message.
		If no faults and programmed for		Display mode. Stop LED on.
		LOCAL operation.
Press PROG key		Enter program mode.
Press Y or B key		Scroll to Level 2 Blocks.
Press ENTER key		Select Level 2 Blocks.
Press Y or B key		Scroll to the Miscellaneous block.
Press ENTER key		Select Miscellaneous block.
Press Y key		Scroll to Factory Settings
		parameter.
Press ENTER key		Access Factory Settings		V represents blinking cursor.
		parameter.
Press Y key		Scroll to YES, to choose original
		factory settings.
Press ENTER key		Restores factory settings.		“Loading Presets” is first message
				“Operation Done” is next
Press Y key		Scroll to menu exit.		“No” is displayed last.
Press ENTER key		Return to Level 1 blocks.		Exit Level 2 blocks.
Press Y or B key		Scroll to Programming exit.		Exit Programming mode and
				return to Display mode.
Press ENTER key		Return to display mode.		Display mode. Stop LED on.

4-8 Programming & Operation MN722