Program Mode

The Program Mode is used to:

 

1.

Enter motor data.

 

2.

CALC Presets and Autotune the drive.

 

3.

Customize the drive (Control and Motor) parameters to your application.

From the Display Mode press the PROG key to access the Program Mode.

Note: When a parameter is selected, alternately pressing the Disp and Prog keys will toggle between the Display Mode and the selected parameter. When a

 

parameter is selected for programming, the keypad display gives you the

 

following information:

Parameter

 

 

 

 

 

 

 

 

 

Parameter Status

 

 

Value and Units

 

 

 

 

 

 

Parameter Status. All programmable parameters are displayed with a “P:” in the lower left corner of the keypad display. If a parameter is displayed with a “V:”, the parameter value may be viewed but not changed while the control is enabled. If the parameter is displayed with an “L:”, the value is locked and the security access code must be entered before its’ value can be changed.

Parameter Blocks Access for Programming

Use the following procedure to access parameter blocks to program the control.

Action

Description

Display

Comments

 

 

 

 

Apply Power

Keypad Display shows this

 

Logo display for 5 seconds.

 

 

opening message.

 

 

 

If no faults and programmed for

 

Display mode.

 

 

 

 

 

LOCAL operation.

 

 

 

If no faults and programmed for

 

If fault is displayed, refer to the

 

 

 

 

 

REMOTE operation.

 

Troubleshooting section of this

 

 

 

manual.

 

 

 

 

 

 

 

Press PROG key

 

 

Press ENTER to access Preset

 

 

 

 

 

Speed parameters.

Press Y or B key

Scroll to the ACCEL/DECEL

 

Press ENTER to access Accel

 

 

 

block.

 

and Decel rate parameters.

Press Y or B key

Scroll to the Level 2 Block.

 

Press ENTER to access Level 2

 

 

 

 

 

Blocks.

Press ENTER key

First Level 2 block display.

 

Press ENTER to return to Display

 

 

Press Y or B key

Scroll to Programming Exit menu.

 

 

 

 

 

 

mode.

 

 

 

 

Press ENTER key

Return to display mode.

4-6 Programming & Operation

MN722

Page 53
Image 53
Baldor mn722 manual Program Mode, Parameter Blocks Access for Programming