Baldor mn722 manual Display Screens & Diagnostic Information Access, Display Mode, =OPEN, 1=CLOSED

Display Mode Continued

Display Screens & Diagnostic Information Access

Action	Description	Display		Comments
Apply Power				Logo display for 5 seconds.
	Display mode showing motor			No faults present. Local keypad
	speed.			mode. If in remote/serial mode,
				press local for this display.
Press DISP key 6 times	Scroll to Diagnostic Information			Diagnostic Access screen.
	screen
Press ENTER key	Access diagnostic information.			First Diagnostic Information
				screen.
Press DISP key	Display mode showing control
	temperature.
Press DISP key	Display mode showing bus
	voltage.		XXXV
Press DISP key	Display mode showing %
	overload current remaining.
Press DISP key	Display mode showing opto			Opto Inputs states (Left);
	inputs & outputs states.			Opto Outputs states (Right).
	0=OPEN, 1=CLOSED.
Press DISP key	Display mode showing actual			HR.MIN.SEC format.
	drive running time.
Press DISP key	Display mode showing operating			Typical display.
	zone, voltage and control type.
Press DISP key	Display mode showing continuous			ID is displayed as a hexadecimal
	amps; PK amps rating; amps/volt			value.
	scale of feedback, power base ID.
Press DISP key	Display mode showing which
	Group1 or 2 expansion boards
	are installed and recognized.
Press DISP key	Display mode showing motor
	shaft revolutions from the REV
	home set point.
Press DISP key	Display mode showing parameter
	table selected.
Press DISP key	Display mode showing software
	version and revision installed in
	the control.
Press DISP key	Displays exit choice.			Press ENTER to exit diagnostic
				information.

4-4 Programming & Operation MN722