Canon 2010F manual Orientation, Platen Glass, Vertical Placement Horizontal Placement Feeder

Orientation

You can place an original either vertically or horizontally. Always align the top edge of your original with the back edge of the platen glass (by the arrow in the top left corner), or with the back edge of the feeder.

Platen Glass

TX Terminal ID

Printed Here

Place the

original

face down.

TX Terminal

ID Printed

Here

Place the original face down.

3

Sending

Vertical Placement Horizontal Placement

Feeder

Basic

ABC

TX Terminal ID Printed Here

Place the original face up.

ABC

TX Terminal ID Printed Here

Place the original face up.

Vertical Placement Horizontal Placement

IMPORTANT

•If the top edge of the original is not aligned with the back edge of the platen glass (by the arrow in the top left corner), prints may not be made correctly, depending on the mode you have set.

•If an original is scanned facing the wrong direction, the sender information is not printed in the correct position on the fax.

NOTE

•LTR originals can be placed either vertically or horizontally. However, the scanning speed for horizontally placed originals is somewhat slower than for vertically placed originals.

•Horizontally placed LTR originals are referred to as LTR .

•11" x 17" and LGL originals must be placed horizontally.

•To get the same output result when you are using the feeder as when the original is placed on the platen glass, place the original upside-down and face up in the feeder. However, when using the Staple mode, the finisher rotates the output automatically.

Placing Originals 3-7